Chiller installation in Jumeirah 

Chiller installation in Jumeirah: local context

Jumeirah is a long-established coastal district stretching along Jumeirah Beach Road and Al Wasl Road, made up of villas, low-rise residential buildings, boutique hotels, clinics and street-front retail. Much of the stock dates from the 1980s–2000s, and older villas are steadily being demolished and rebuilt as larger homes, clinics or small commercial buildings. Manolia completed the MEP works for a B+G+4 building here.

• Sea air within a few hundred metres of the beach attacks condenser coils, fixings and exposed electrical enclosures, so coated coils, stainless or hot-dip galvanised supports and IP-rated outdoor gear pay off.
• Clinics and medical centres converted from villas need fresh-air AHUs, extract for treatment rooms, medical gas coordination and resilient power for critical equipment.
• Basement buildings near the coast must allow for groundwater, with sump pumps, waterproofed penetrations and drainage designed for reliable discharge.

Building types we serve in Jumeirah

For clinics and healthcare facilities, the work concentrates on pressure regimes between rooms, high-grade filtration, essential power with UPS back-up and infection control while works are under way.

Scope of work

• Structural and acoustic coordination for roof or plant-room locations, including spring isolators, inertia bases and maintenance clearances around each machine.
• Rigging and lifting plans for heavy chillers onto roofs or into basements, coordinated with crane availability and site logistics.
• Plant manager and BMS integration for sequencing, staging and alarm reporting, followed by manufacturer start-up and performance verification.
• Refrigerant leak detection and plant-room ventilation where water-cooled machines sit indoors, wired to alarm and to start the emergency extract fans.

Systems we install

• Primary-secondary or variable primary pumping arrangements
• Chemical dosing and side-stream filtration on the chilled-water loop

UAE site and climate challenges

• Dust and sand clog condenser coils and reduce heat rejection, so coil cleaning access, coatings for coastal sites and a planned cleaning regime are built into the handover.
• Roof plant on towers is often installed months before handover and left idle in the sun, so chillers are protected, crankcase heaters energised when power arrives, and controls checked for heat damage before manufacturer start-up.
• Air-cooled versus water-cooled: air-cooled needs no cooling tower or water treatment and suits most towers, while water-cooled is more efficient but needs make-up water, treatment and more maintenance.

Relevant Manolia projects

Hassani Group factories & HQ, DIP

Dubai Investments Park (DIP) · MEP · Completed

Factory complex, HQ and staff accommodation, all served from one central cooling station.

6 buildings G+2

Driving centre (6 buildings), DIP

Dubai Investments Park (DIP) · HVAC · Completed

HVAC on district cooling with an underground chilled-water network.

Frequently asked questions