MEP design and build in Al Taawun 

MEP design and build in Al Taawun: local context

Al Taawun runs along the northern shore of Al Khan Lagoon near Expo Centre Sharjah, a district of residential high-rises, office towers and shopping centres built mostly from the 2000s. Its towers sit on podium car parks fronting a busy main road. The area combines new developments with towers now due for system upgrades. Traffic along Al Taawun Road is heavy throughout the day.

• Office and residential towers typically use central chilled-water plants with cooling towers or air-cooled chillers; replacement projects must keep cooling running while old plant is removed.
• Lagoon humidity and salt drive corrosion on roof equipment and podium-level plant, so coatings and inspection regimes matter.
• SEWA connection, metering and inspection requirements apply, alongside Sharjah Civil Defence review of fire systems.

Building types we serve in Al Taawun

For office buildings, the work concentrates on VAV or FCU zoning for flexible floor plates, tenant fit-out interfaces, energy metering and BMS integration.

Scope of work

• Cooling and heating load calculations, ventilation rates, electrical load schedules, water demand and drainage fixture-unit calculations for authority and utility submission.
• Preparation of authority drawings for Civil Defence, DEWA, SEWA, ADDC or the relevant utility, and green-building compliance under Al Sa'fat or Estidama where applicable.
• Procurement of equipment against the design intent, with submittals that keep selections inside the calculated duties rather than swapping in undersized alternatives.
• Installation, testing, commissioning and handover by the same organisation, closing the loop between design assumptions and measured performance.

Systems we install

• Ventilation, kitchen and car park extract, smoke management and stair pressurisation systems.
• Water supply, booster pumping, hot water, drainage and rainwater systems sized from fixture-unit calculations.

UAE site and climate challenges

• UAE design ambient temperatures around 46°C dry bulb with high coastal humidity drive both sensible and latent loads. We design fresh-air systems to dehumidify outdoor air properly, because under-dehumidified ventilation is the main cause of mould and sweating ducts in UAE buildings.
• Solar gain through glazing on west and south facades dominates perimeter loads. Our load models use the actual facade specification and orientation, and perimeter zones are separated so a sunlit side does not overcool the shaded interior.
• Water-cooled versus air-cooled chillers: water-cooled plant is more efficient in UAE heat but needs cooling towers, water treatment and make-up water; air-cooled is simpler and usual for mid-size buildings without water allowances.

Relevant Manolia projects

Frequently asked questions