MEP design and build in International City 

MEP design and build in International City: local context

International City is a large low- and mid-rise community off the Al Ain Road and Emirates Road, organised into country-themed clusters of apartment buildings with ground-floor shops, alongside trading and warehouse areas such as Dragon Mart. Built from the mid-2000s, it offers some of Dubai's most affordable housing and is densely occupied. Maintenance and refurbishment are a big part of the MEP workload here.

• Low-rise apartment blocks typically run split or packaged units, so refurbishments focus on replacing ageing outdoor units, fixing condensate drainage and upgrading electrical distribution.
• Approvals may run through Dubai Municipality or Trakhees depending on the cluster, with Civil Defence review for fire systems in retail and warehouse areas.
• The open inland setting brings dust and heat, so outdoor equipment needs regular coil cleaning and adequate shading.

Building types we serve in International City

For mid-rise residential and mixed-use buildings, the work concentrates on compact plant on the roof, car-park ventilation in podiums, metered apartment DBs and tight ceiling voids that make coordination drawings decisive.

Scope of work

• Cooling and heating load calculations, ventilation rates, electrical load schedules, water demand and drainage fixture-unit calculations for authority and utility submission.
• Selection of the HVAC approach, whether district cooling connection, central chilled water, VRF or packaged units, based on loads, plot constraints and lifecycle cost.
• Preparation of authority drawings for Civil Defence, DEWA, SEWA, ADDC or the relevant utility, and green-building compliance under Al Sa'fat or Estidama where applicable.
• Installation, testing, commissioning and handover by the same organisation, closing the loop between design assumptions and measured performance.

Systems we install

• HVAC plant: chillers, district cooling energy transfer stations, AHUs, FCUs and fresh-air units.
• Building management system, metering and controls integration across all mechanical and electrical plant.

UAE site and climate challenges

• UAE design ambient temperatures around 46°C dry bulb with high coastal humidity drive both sensible and latent loads. We design fresh-air systems to dehumidify outdoor air properly, because under-dehumidified ventilation is the main cause of mould and sweating ducts in UAE buildings.
• Air-cooled equipment loses capacity as condenser inlet air gets hotter, and roof plant often sees air several degrees above ambient. We derate selections for real roof conditions and space units to avoid hot-air recirculation.
• District cooling versus own chiller plant: district cooling removes plant space and maintenance but involves connection and capacity charges, while own plant gives control but needs roof or basement space and an operations team.

Relevant Manolia projects

G+6+HC

G+6 building with health club, DSO

Dubai Silicon Oasis (DSO) · MEP · Completed

Full MEP package delivered.

Hassani Group factories & HQ, DIP

Dubai Investments Park (DIP) · MEP · Completed

Factory complex, HQ and staff accommodation, all served from one central cooling station.

Frequently asked questions