MEP design and build in Fujairah City 

MEP design and build in Fujairah City: local context

Fujairah City is the east-coast capital on the Gulf of Oman, with residential districts, hotels, government buildings and industrial areas linked to the port. The city's building stock is mostly low- and mid-rise, with apartment buildings, villas, offices and beach hotels, while industrial and storage facilities cluster towards the port and the oil terminals. Mountains rise directly behind the city, giving it a different microclimate and terrain from the west-coast emirates.

• Humid, salt-laden air off the Gulf of Oman attacks condenser coils, roof fixings and outdoor electrical enclosures, so coated coils, stainless supports and IP-rated gear are specified from the outset.
• Industrial plots near the port may face additional fire protection requirements.
• Heavy rain events from the mountains can cause sudden runoff, so drainage and plant-room flood protection deserve attention.

Building types we serve in Fujairah City

For villas and townhouses, the work concentrates on ducted split or VRF systems, roof tanks and booster pumps, hot water, pool plant and clean concealed routing that respects architectural finishes.

Scope of work

• Preparation of authority drawings for Civil Defence, DEWA, SEWA, ADDC or the relevant utility, and green-building compliance under Al Sa'fat or Estidama where applicable.
• Development of detailed design into coordinated shop drawings, with clash detection between ducts, pipes, cable trays and structure before procurement.
• Procurement of equipment against the design intent, with submittals that keep selections inside the calculated duties rather than swapping in undersized alternatives.
• Installation, testing, commissioning and handover by the same organisation, closing the loop between design assumptions and measured performance.

Systems we install

• Ventilation, kitchen and car park extract, smoke management and stair pressurisation systems.
• Water supply, booster pumping, hot water, drainage and rainwater systems sized from fixture-unit calculations.

UAE site and climate challenges

• UAE design ambient temperatures around 46°C dry bulb with high coastal humidity drive both sensible and latent loads. We design fresh-air systems to dehumidify outdoor air properly, because under-dehumidified ventilation is the main cause of mould and sweating ducts in UAE buildings.
• Solar gain through glazing on west and south facades dominates perimeter loads. Our load models use the actual facade specification and orientation, and perimeter zones are separated so a sunlit side does not overcool the shaded interior.
• Water-cooled versus air-cooled chillers: water-cooled plant is more efficient in UAE heat but needs cooling towers, water treatment and make-up water; air-cooled is simpler and usual for mid-size buildings without water allowances.

Relevant Manolia projects

AUS Bowling City, Sharjah

University City (Sharjah) · MEP · Completed

MEP design & build plus decoration for a G+4 leisure building.

MEP Design

42-building complex, mall & hotel, Ajman (design)

Ajman · MEP Design · Design

MEP design for a mixed-use masterplan including a 5-star hotel.

Frequently asked questions